Micro Focus QTP (UFT) Forums

Micro Focus QTP (UFT) Forums > Micro Focus UFT (earlier known as QTP) > UFT / QTP Beginners > Problem Add Parameter Data Table
Full Version: Problem Add Parameter Data Table
You're currently viewing a stripped down version of our content. View the full version with proper formatting.

aramcos81

02-02-2010, 07:42 PM
I would write a value to Global Sheet or Local Sheet.
If I use this command "DataTable.GlobalSheet.AddParameter "B" ,1
I don't view parameter in DataTable.
Is it correct?

Saket

02-03-2010, 02:23 PM
whatever you do at runtime, is applicable during the run session only.
so when you add a new parameter, it is getting added at runtime, but will not be there permanently.
check your result, it must be added in the run time data table.
Micro Focus QTP (UFT) Forums > Micro Focus UFT (earlier known as QTP) > UFT / QTP Beginners > Problem Add Parameter Data Table