02-26-2008, 05:40 PM
I am automating an application which is build in power builder.The automation work was going fine,until i faced this issue.
I am unable to retrieve a value from a table as the QTP is recognizing is as a Win Object and not as a Table.I tried Low Level Recording but in vain.I tried using RO properties to retrieve the x,y co-ordinates of each row but since different number of rows are present as a new table is created each time,so it didn't worked.Virtual objects also didn't work.
I have to use QTP 8.2 version only.
If you have any suggestions then it would be of great help.
I am unable to retrieve a value from a table as the QTP is recognizing is as a Win Object and not as a Table.I tried Low Level Recording but in vain.I tried using RO properties to retrieve the x,y co-ordinates of each row but since different number of rows are present as a new table is created each time,so it didn't worked.Virtual objects also didn't work.
I have to use QTP 8.2 version only.
If you have any suggestions then it would be of great help.